Test Configuration: 2+0 / 4+0 IP-20N Link. The following test equipment can be used for automated testing: The diagram in Figure 1 shows the start-up configuration need to be set to facilitate the testing. To determine the System running without unexpected performance degradation. The test aims to assess the system’s capability to support the required link capacities, system latency and back-to-back frame loss. The items that need to be clarified will be captured in the “Remarks” section Requires Clarification (RQ) – The system meets Optus requirement, subject to Vendor providing further clarifications/explanations in relation to the test outcome.Fail (F) – the test did not meet Optus requirement.Pass Conditional (PC) – the test only partially meets Optus requirements, with the aspects of the non-compliance captured in the “Remarks” section.Pass (P) – the system fully satisfies Optus requirement.The individual tests are usually marked in accordance with the following criteria: ![]() The RFC 2544 tests to measure the following These packets are sent to a device that functions as the reflector, which receives and returns the packets back to the initiator. RFC 2544 tests are performed by transmitting test packets from a device that functions as the generator or the initiator. RFC 2544 defines a series of tests that can be used to describe the performance characteristics of network interconnecting devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |